WashingMachineHoses.com is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

How to Check the Pressure Switch

Step-by-Step Guide: Checking Your Pressure Switch Made Easy

Checking the pressure switch is an important task for maintaining the performance of your HVAC system. The pressure switch is a safety device that ensures your system is operating within safe parameters. In this article, we will go through the step-by-step process of checking the pressure switch.

Step 1: Turn off the power supply

Before starting any maintenance task, always turn off the power supply to the system. This will prevent any electrical accidents from occurring during the process.

Step 2: Locate the pressure switch

The pressure switch is usually located near the blower motor or on the outside of the furnace. It is a small device with two wires connected to it.

Step 3: Remove the wires from the pressure switch

Using a pair of pliers, gently remove the wires from the pressure switch. Take note of which wire goes where, as you will need to reconnect them later.

Step 4: Test the pressure switch

Using a multimeter, test the pressure switch for continuity. Set the multimeter to the continuity setting and touch the probes to the terminals on the pressure switch. If there is continuity, the pressure switch is functioning properly. If there is no continuity, the pressure switch needs to be replaced.

Step 5: Check the pressure switch for debris

If the pressure switch is not functioning properly, it may be due to debris clogging the switch. Inspect the switch for any debris and clean it using a soft brush.

Step 6: Reconnect the wires

After testing and cleaning the pressure switch, reconnect the wires to their respective terminals. Make sure they are securely fastened.

Step 7: Turn on the power supply

Once you have completed the previous steps, turn on the power supply to the system. Test the system to ensure it is functioning properly.

In conclusion, checking the pressure switch is an important task for maintaining the performance of your HVAC system. By following these simple steps, you can ensure that your pressure switch is functioning properly and your system is operating within safe parameters.