WashingMachineHoses.com is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Check the Water Level Switch
1 Multimeter
2 Screwdriver set
3 Pliers
4 Wire stripper
5 Electrical tape
6 Replacement water level switch (if needed)

How to Check the Water Level Switch

Step-by-Step Guide to Checking Your Water Level Switch

Checking the water level switch in your washing machine is an important step in maintaining its functionality. The water level switch, also known as the pressure switch, is responsible for regulating the amount of water that enters the machine during a wash cycle. If the switch is faulty, it can result in overfilling or underfilling of the machine, which can cause damage to your clothes or the machine itself. Here are the steps to check the water level switch:

Step 1: Turn off the washing machine and unplug it from the power source. This is important for your safety and to prevent any electrical damage to the machine.

Step 2: Locate the water level switch. It is usually found at the top of the machine, near the control panel. The switch is connected to a small tube that runs down to the bottom of the washing machine.

Step 3: Remove the tube from the water level switch. You can do this by gently pulling it out of the switch. Make sure to hold onto the tube so that it doesn't fall back into the machine.

Step 4: Blow into the tube to clear any blockages. If you hear a clicking sound, it means that the switch is working properly. If you don't hear a clicking sound, the switch may be faulty and needs to be replaced.

Step 5: Check the switch for any visible damage or wear and tear. If the switch looks damaged, it may need to be replaced.

Step 6: Reconnect the tube to the water level switch. Make sure it is securely attached to the switch.

Step 7: Plug the washing machine back in and turn it on. Run a test cycle to see if the water level switch is working properly. If the machine fills up with the correct amount of water, the switch is working properly.

In conclusion, checking the water level switch in your washing machine is a simple process that can help you avoid potential damage to your clothes or machine. By following these steps, you can ensure that your machine is functioning properly and avoid any unnecessary repairs or replacements.